MK3s+ extruder motor and gear cooler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a remix of a extruder motor cooler. This is for the new MK3s+ that has some airflow over the Bondtech gears.
- Ocena
- 4,75 / 5
- Polubienia
- 23
- Pobrania
- 95
- Wydruki
- 3
- Wyświetlenia
- 2152
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a remix of a extruder motor cooler. This is for the new MK3s+ that has some airflow over the Bondtech gears.
This one uses both openings on the left side of the extruder but doesn't block the tension screw for the Bondtech gears.
I haven't tested it yet. But with the parts that I have printed I have checked that there is enough room to move freely.
Print instructions
I printed this in PETG. PLA is to brittle to bend and install.
0.2mm layer height and 15-20% infill.
There is no need for supports. I added a little support in the print to support the part that fits next to the Bondtech tension screw.
That support is easy to cut off.