Raspberry Pi fan case for 3B or 3B+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact ventilated fan case with 30mm fan.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 412
- Wydruki
- 3
- Wyświetlenia
- 1404
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Raspberry Pi 3(B/B+) compact ventilated fan case
Compact ventilated fan case with 30mm fan.
Snap fit top cover screwless design.
Requires 1x 30mm 5V DC fan with fixing centres of 24mm.
The fan fits to the top cover with 4x 12mm M2.5 screws & nuts and connects to pins 1 (3v3) or pin 2 (5v) and 9 (GND).
I have tried to make the case as small as possible so the Pi is a snug fit.
To install the Pi, angle it so as to engage the audio jack and hdmi sockets first then press the Pi down on to the 4x standoffs on the case bottom.
Current use is for Octoprint where there is no need to expose the Pi's pin headers so I have also included a top cover with gpio slot cutout in case its needed.
4x 8x3mm High silicone self adhesive feet stop the case sliding around.
I used supports for the sd card slot and hdmi, micro usb and rj45 sockets.
Printed in PLA at 0.2mm
I've included STEP files as well as STL to make it easier to modify if required.
Hardware
1x 30mm 5V DC fan
4x 12mm M2.5 screws & nuts
4x 8x3mm High
Hope the helps someone.