1 / 1
PSU Holder for the black power supply (Prusa MK3/MK4) — zdjęcie 1

PSU Holder for the black power supply (Prusa MK3/MK4)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for the black PSU of the Prusa MK3 or MK4. Uniquely, you can mount the PSU horizontally instead of vertically!

Ocena
5 / 5
Polubienia
37
Pobrania
245
Wydruki
11
Wyświetlenia
1330
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wenn du deinen Drucker in einem Gehäuse betreiben willst, solltest du das Netzteil ausserhalb des Gehäuses anbringen. Da ich keine Halterung für das schwarze Netzteil gefunden habe, um das Netzteil möglichst platzsparend unter dem Gehäuse zu befestigen, habe ich dieses Teil selbst konstruiert.

Die Halterung zeichnet sich dadurch aus, dass sich das Netzteil horizontal liegend unter dem Gehäuse befestigen lässt und dieses mit nur einer Handbewegung wieder entfernbar ist. Der Ein-/Ausschalter des Netzteils ist durch die liegende Position gut erreichbar.

Aufgrund der etwas höheren Temperaturbeständigkeit habe ich die Teile in PETG gedruckt. Ich denke aber, PLA wäre auch ausreichend. Du benötigst für den Zusammenbau nur vier Holzschrauben mit 4mm Durchmesser.

Achte bei der Montage darauf, dass die Lüftungsschlitze des Netzteils nicht verdeckt werden!
 

--------------

If you want to operate your printer in a housing, you should attach the power supply unit outside the housing. Since I couldn't find a bracket for the black power supply to mount the power supply under the housing to save space, I designed this part myself.

The holder is characterized by the fact that the power supply can be attached horizontally under the housing and it can be removed with just one hand movement. The on/off switch of the PSU is easily accessible due to its lying position.
You only need four wood screws with a diameter of 4mm for assembly. Due to the slightly higher temperature resistance, I printed the parts in PETG. But I think PLA would also be sufficient.
During assembly, make sure that the ventilation slots of the power supply are not covered!

Tagi