Water Valve RC controlled
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have a lot of fun chasing the kids with my micro drone and squirting them with water. This is the assembly I made…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 705
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I have a lot of fun chasing the kids with my micro drone and squirting them with water. This is the assembly I made using some IV components, surgical tubing and a micro RC servo.
The surgical tubing is filled with about 30ml of water through a Luer lock connector with a one way valve. The R-lock is modified on one end to allow attaching a length of 3mm ID x 5mm OD surgical tubing. I tie it securely with some small thread. This could all come apart and spray water so protect your electronics appropriately.
I used this servo but any one that size should work. https://www.amazon.com/K-Power-P0025-Coreless-Airplane-arduino/dp/B098FG3LJF/ref=sr_1_17?crid=4BJM90JX65LK&keywords=pk-p0025+servo&qid=1685194227&sprefix=pk-p0025+servo%2Caps%2C89&sr=8-17
The R-lock came from an extra IV set I had but I have seen them for sale on ebay. I bet a quick trip to a local infusion center and you might find one for free. They come in the infusion set I got and I've never used them.
If you find that you are not pinching off the line, you can add a little piece of thin plastic to the flat spot on the bottom to build it up until you're good.
If you tighten the 2mm x 15 mm screw it should stay locked after charging and you could use a string to trigger it instead of the servo.
Have Fun!
Cheers
KIsssys
Category: Electronics