TBS Sourceone V3 Front Bumper Ghost Antenna
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Immersion Ghost 2.4 antenna up front, and protect the front bottom plate from crash damage.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I run an elrs 2.4 dual rx on my 7" sourceone v3, and needed a better front mount to go with it. So I designed this in f360, and it works well. It features a stiff mount for less vibes, and no printed material wrapping the feed point or active elements.
Print the stl in TPU, no rotation necessary but supports are required. Install it on your v3, push antenna in from the front, and enjoy!
Note: For quads where long range will matter, this mount should not be used with non-diversity rx's. The low in front horizontal position is easily blocked by the quad, compared to vertical high in the rear. On my 7" sourceone, I have this front horizontal, and a high rear vertical antenna to go with it. They complement each other very well this way.