1 / 3
M200 fan bracket with standoffs included (10mm or 15mm) — zdjęcie 1
1 / 3

M200 fan bracket with standoffs included (10mm or 15mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

M200 fan bracket with standoffs

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
91
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Added standoffs to the excellent Thing - via TinkerCAD

TinkerCad URL's https://www.tinkercad.com/things/euq0vNNKPMM-mpsm-fan-bed-with-15mm-legs https://www.tinkercad.com/things/fuXjM8w5bWa-mpsm-fan-bed-with-10mm-legs

Haven't installed it yet, still have the original in place - standoffs should fit between components, hopefully

1st draft was a mirror image of what I needed :o(

Update

Installed and working perfectly - plenty of space for the posts

If you are using the fan header on the motherboard you will need motion firmware v26 or above, as i understand its not enabled on earlier firmware. Also you may, I did, need to swap the wires over on the fan for it to work as they made a mistake when they wired the header. Before you swap any wires over though test you fan on the header that powers the head cooling fan. If you fan works there it will work on the motherboard fan header. If it doesn't swap the cables on your new fan in it's connector and retry it. Wires can be 'easily' pulled out of the connector. They have a small lip that stops them pulling out by accident. You need to gently push that in at the end nearest to the cable - ie away from the edge that connects to the motherboard

40mm fan

Print Settings

Rafts:

Doesn't Matter

Supports: 

No

 

Tagi