Ender 3/pro/v2 Feet Riser - 38mm/45mm total clearance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
No print support needed. On the Ender3v2 you can reuse the silicon feet (not sure what other printer have)
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 228
- Wydruki
- 4
- Wyświetlenia
- 1366
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an old design of mine, nothing fancy, simple but they work well.
- v1 might interfere with cases that fit under the printer.
- v2 has the same rail shape, but has a vertical inner wall to avoid colliding with cases that go under the printer
- v3 has new rail interface, otherwise same as v2
38mm and 45mm are the total clearance including rubber feet
print sideways (so that rails are vertical and print well)
no support needed (overhang should print well)
original rubber pad can be ripped carefully and reused here
Don't cleanup the glue off the feet so it sticks even better.
Might need to remove larger glue residue off the printer, but may want to to keep some residual glue to have a tighter fit.
If rail are too thick with your printing tolerance, you can scale them down a tiny bit
Use a small rocking motion to slide it into the extrusion
------
Support me on Patreon !
https://patreon.com/squirrelf3d
or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf