CADDX Vista watertight housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Universal housing for CADDX Vista for wet environments
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 293
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this housing for upgrading my old amphibic Mariner II / SplashDrone, which was equipped with a GoPro 3 in a watertight gimbal and analog video before.
As the Vista produces a lot of heat and needs efficient cooling it cannot be mounted within the watertight fuselage and must be placed below the drones belly.
I decided to pack the Vista tightly between two standard heatsinks with 40x40x11mm in size with additional thermal paste for better heat conduction and to design a 3D printed frame with upper and lower part for connecting all together.
The frame parts are printed with ASA-X for maximised stiffness and heat resistance,
The heatsinks as well as the mounts are attached to the frame parts with CA glue.
The vista is then just layed into the lower housing, the camera cable routed along theside to the single cable outlet. The cable outlet and the contact surface of the lower housing frame are then waterproofed by applying some silicone and after pkacing the upper housing 6 M2 screws will finally fix all together.
For even more security I have then applied “Plasti Dip” rubber coating to the housing gaps by using a small paint brush.
The camera got also waterproofed by applying “Plasti Dip”.
The FreeCad design is included, too.