Hexy pads for Xanoy's phone holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Felt like the pads for Xanoy's phone holder (https://www.prusaprinters.org/prints/40471-phone-holder) needed a bit…
- Ocena
- 4,5 / 5
- Polubienia
- 8
- Pobrania
- 51
- Wydruki
- 3
- Wyświetlenia
- 485
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
Felt like the pads for Xanoy's phone holder (https://www.prusaprinters.org/prints/40471-phone-holder) needed a bit more hex appeal so I did a remix. The hex pattern is designed into the STL so no need to adjust infil.
Print instructions
I printed in Flexfil 98A from the Prusa store. It's a bit too rigid but better than just hard plastic.
Print the pads with the patterns on the bed and two top layers. I set one perimeter, thin wall detection on and bridge detection on. Not sure if those are essential. It helps to print all the parts in one go so the small top layers have time to cool down.