Small vacuum cleaner nozzle for 31.5mm hoses
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wasn't happy with the simplistic nozzles available here, so I made this slightly neater one.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 118
- Wydruki
- 0
- Wyświetlenia
- 447
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Our vacuum cleaner didn't come with one of those smaller vacuum nozzles that you use to clean pillows and stuff. I didn't find anything sensible here, so I created my own. The model like it is in the STL is meant to fit the outside of the vacuum hose. The model has an internal diameter of 31.5mm at its end, and a slight taper.
Print with supports on build plate only, turned over on its side like shown in the last picture (the one with the part highlighted in green).
I created the model using Onshape. You can find the document at [this link](https://cad.onshape.com/documents/ec8666c8222218ba0f491ac0/w/9ba295cf72cb1212117c8788/e/b2d7d8ea900170c2169cf24e).
The model uses variables for the hose diameter. Feel free to copy it, and adjust the hose parameters to your needs. If you don't want to create an onshape account for yourself or you can't figure out how to adjust the model, feel free to drop me a message and I can upload other diameters here. I just couldn't find a table of common sizes. When measuring, it's best if you measure not the hose end, but the accessories that came with the vaccum cleaner. Measure the largest diameter, just at the opening, and the diameter 1.5-2.5cm below that to figure out the taper.