Cat Ears for AKG K240 headphones
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a variant of the cat ears from https://www.thingiverse.com/thing:32885 with the ribbon hole and the big logo…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 383
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
This is a variant of the cat ears from https://www.thingiverse.com/thing:32885 with the ribbon hole and the big logo removed, along with an adapter to mount them to AKG K240 or similar headphones. The mount works by hooking a hair tie over the top and into the hooks underneath. To mount the ears to the support blocks, simply glue them down at an angle of your choosing.
The support block should work with other headphones as well. I have tested it with AKG K240 Studio and K240 MK II, but other AKG headphones using round wire in a "V" shape should work too, e.g. K271 MK II. From pictures, I think it won't work on K175 and K245 because it seems their wires are much thicker than the ~4mm of the K240.
Print Settings
Printer Brand:
Anycubic
Printer:
i3 Mega
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Filament:
Whatever PLA
Notes:
Print the support block standing upright on its wider end with supports enabled on build plate only. The generated suports under the base area and the two hook rails should be easy to remove.
Category: Accessories