Worm Tower / Wurmturm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model can be used as an additional compost for raised garden beds. Worms and insects can access through the holes.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 674
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Use the worm tower for composting kitchen waste from potatos, apples, other fruits, egg shells or anything else which will have good impact for your raised garden beds.
Through the holes in the pipe insects and worms can access the waste and bring the compost to your plants.
There are two versions:
v1 20 cm diameter
v2 15 cm diameter
Just try what fits better between your plants.
The models can be printed without supports.
Print the Lid with PETG because it will be set into direct sunlight.
The body can be printed in PLA or PETG, most of it is set under earth, not much direct sunlight.
EDIT: I had some issues with the lid and fitting in to the tower. Just try to print it a little bit smaller (97%) so it will get out easier when its dirty.