Dock cover with laptop stand for HP G25 USB C dock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This covers the HP G25 dock and allows the laptop to be mounted above it, and allows access to the ports on the side.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 546
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This covers the HP G25 dock and allows the laptop to be mounted above it, and allows access to the ports on the side. I'm sure it will fit other docks as well, it's not that tight a fit to allow the connecting cable to route under it to the back. It should also fit most laptops, I've put a MacBook Air, MacBook Pro, and a larger HP business laptop in it, the laptop opening is 23 mm.
It is printed in 3 pieces, the top and 2 legs. Supports are only needed on the right leg due to the access opening for the side ports of the dock. I would print the leges standing up since assembly is just using friction and support artifacts may make that difficult. If you don't need the opening that is in the right leg you should be able to just print 2 of the left leg models.
Printed as is on my Ender 3 S1 with the Sonic Pad the tolerances were dead on, you may have to play with doing 98% or so on your printer for the legs depending on your printers tolerances
Printed in PLA - Overture Matte Black and Chocolate with 20% infill and .25 layer height.