Sujección cables de la cama caliente de Kingroon KP3S.-Kingroon KP3S heated bed cable fastening.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sujetar de forma segura y muy rápida los cables de la cama caliente de KP3S (sin usar tornillos).Hot bed cable fastening
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 396
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
La sujección de los cables de la cama caliente de la Kingroon KP3S no es que sea muy buena que digamos.
The fixing of the cables of the heated bed of the Kingroon KP3S is not very good to say.

Está sujeta por sólo una brida, con lo que los cables oscilan continuamente con el movimiento.
It is supported by only one flange, so the cables oscillate continuously with the movement.
Entonces he pensado en una pieza que se coloque en segundos, sin utilizar tornillos ni desmontar nada. Tan sólo cortando la brida original.
So I thought of a piece that can be placed in seconds, without using screws or disassembling anything. Just cutting the original flange.

La pieza impresa se inserta como un capuchón dentro del carro metálico y los cables se sujetan con dos bridas por encima. De esta manera queda unida la pieza con el carro del eje Y y a su vez se sujetan los cables firmemente con lo que se incrementa la duración de los mismos.
The printed part is inserted like a cap inside the metal carriage and the cables are held with two flanges above. In this way, the piece is attached to the Y-axis carriage and, in turn, the cables are firmly held, thus increasing their duration.
Recomiendo imprimir como en esta captura de pantalla, añadiendo soportes en la zona interior de forma automática (con el relleno inteligente del Prusa Slicer). A 0,15 de altura de capa y al 60% de relleno será suficiente.
I recommend printing as in this screenshot, adding supports in the inner zone automatically (with the smart padding of the Prusa Slicer). At 0.15 layer height and 60% infill will suffice.

Espero que os sea útil.
I hope it is useful to you.