CR6-SE Orbiter 2.0 Mount

This is a mounting adapter use the Orbiter 2.0 Extruder(and sensor if desired) with the CR6-SE Printer.  

As it uses one of the mounting holes for the stock enclosure, it is not currently compatible with the stock part cooling fan(which is mounted to the enclosure).  Instead, I use and would highly recommend the adjustable dual fang cooling shroud remixed by @michelluccote.  I have not tested it with the original design by @K2Van, so if anyone does try it, please let me know and I will update this accordingly.  

This design uses:

2x m3x10 Socket head screws

1x m3x8 Socket head screw

2x m3x4.6x4 Brass heat inserts

Screws: https://www.amazon.com/gp/product/B09WK8W5G1/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

Heatserts: https://www.amazon.com/gp/product/B08BJD3W4X/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

This design is intended to have a short PTFE tube go from the extruder, through the mounting plate, to the hot end, similar to the setup suggested by Bondtech for the LGX.

I printed in PETG with an infill of 40% and a layer height of 0.2mm.  

Update 12/19/23 - Added requested formats and the Beta folder

Important note 

The “Beta version” folder is untested and will remain so until i can get to it.  I had the standard version flex a little more than I liked, so the new version has some additional material, adding strength between the orbiter mounting plate and the gantry mount.  If you try it, please let me know if it works well.  Thank you!