Z endstop support adjustable (reprapdiscount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adjustable Z support for the mechanical endstop from reprapdiscount.com. The clamp diameter is for a 10 mm stub. It is…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Adjustable Z support for the mechanical endstop from reprapdiscount.com.
The clamp diameter is for a 10 mm stub.
It is inspired from oTTo's support http://www.thingiverse.com/thing:16458
2020/09/03: Revision 3 is just a little bit more accurate and made with Freecad, the previous one was made with SketchUp.
Print Settings
Printer:
CR-10 V3
Supports:
Yes
Resolution:
0.2
Infill:
70
Notes:
No raft needed but a brim may be used for better adhesion.
Instructions
The supports need to be removed to leave the room for the pins soldered crossing the circuit board.
The raft can be peeled off, sometime a drill bit is needed for the hole.
BOM:
2 x M3x30 screws
2 x M3 nuts
1 x Spring (mine is 7x15 mm from paoparts.com)
Category: 3D Printer Parts