S-Pen Art Stylus

This is a Wacom-like Art-Pen stylus adapter for a Samsung phone S-Pen. I made it to fit my Galaxy Note 10+ S-Pen. It should be compatible with every S-Pen from the Note 9 up to the Galaxy S23 Ultra.

Samsung tablet S-Pens are a little different. This is not for them.

I chose not to use a screw to hold the cap on, but a simple twist locking mechanism. The spring pressure from the clicky cap on the S-Pen is all that  is needed to keep the cap on.

It features small alignment indicators to help with assembly / disassembly.

Printing Instructions:

This took some fiddling to get it fitting correctly. I have uploaded the files that worked for me  however you may need to increase or decrease the scale on your printer to get yours to fit correctly.

I did not print this in FDM I printed it in resin. I dont know how well it will turn out in FDM.

If you print in resin: No supports are necessary. Also be sure to thoroughly clean and remove all internal residue. before/After curing. 

Both sides should be placed in the center of the print bed like this:

WARNING!

• Do not force your S-Pen into the print. It should slip in freely to the bottom.
• The S-Pen should take next to no force to remove as well. 
• if you pull too strongly on the clicky cap it will break.
• ( Push from the tip of the pen rather than pulling from the clicker if this is a problem )
• Scrap your print, adjust the scale, and try again if it fails any of these points.
• If you force it, it will get stuck and you might break your S-Pen!

Here is a demonstration on how it should properly fit:

https://www.youtube.com/shorts/3D31L4ueHXk