Water Ingress/Egress Test Article
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With this 50x50mm hollow article you can test the moisture barrier integrity of your print before or after waterproofing
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 91
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
Many 3D makes are intended for outdoor service, especially instruments of any kind. This simple design with 2mm thick walls can be used to pre-test your printer profile, filament choice and filament settings before printing the final housing design. To test for water egress simply fill the article and place it upon a telltale surface. To test for water ingress fill the article, seal the opening with a 12x12x2mm thick patch of 3M self-stick silicone and place the dry, sealed article outside in the elements. A bottom boss with blind hole is provided to accept a 5mm placement shaft if so desired. If post printing surface treatments, such as acetone smoothing, paint, flex-seal spray etc. - are required (likely will be) this same test article and test procedure can be reengaged.