LM8UU Bearing pusher/helper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This helps you install or remove LM8UU bearings from tight spaces without damaging the bearing seal
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 158
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
About this little tool:
I needed something at least 25mm in length to assist me installing and removing LM8UU bearings from my printed parts with very tight clearances. I used to push the bearing against a table and then to center it, I pushed it with the back side of a screw driver, which has worked with great results, but after messing up a few bearing seals, a few cuts, bruises and loads of swear words later, I quickly designed this simple model and it has been working a treat. It also saves the bearing seal from damage, ask me how I know, lol.
Print settings:
- Layer Height: 0.2-0.25
- Recommended Infill: 50% or higher if your clearances are as tight as mine, nothing less then 50% rectilinear infill will do
- Material: I printed mine in Wanhao PLA and it has been holding up nicely
- Walls: 4 walls
- Top/Bottom: 4 Top and 4 Bottom layers
You are welcome to remix this if you need it taller or shorter, but the 25mm length is perfectly enough for my use at current.
EDIT: I noticed I forgot to add the step file, it is now included.