Action Figure Stand for 8-12 inch models
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very basic stand with spring hooks around waist height. NO SUPPORTS.
- Ocena
- 5 / 5
- Polubienia
- 104
- Pobrania
- 960
- Wydruki
- 5
- Wyświetlenia
- 3677
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Share Alike
A very simple stand, designed to not obscure your figure very much. Designed specifically for the figure pictured, but a very simple modification to the length of the strut would let you adapt it to any height. You'll need two braces per stand. All pieces are designed to print easily with no supports - just make sure the braces are the right way down, as the pin that fits into the strut is only flat with the spring one way.
You shouldn't need much infull to make it strong enough, but you might want to with higher infill for the base just for extra weight for stability.