EZPass Holder with Suction Cups (for New Slim Rectangular Model)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An EZPass mount/holder that uses common suction cups to secure the device to your windshield.
- Ocena
- 4 / 5
- Polubienia
- 4
- Pobrania
- 114
- Wydruki
- 1
- Wyświetlenia
- 913
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This EZPass mount is designed for the newer slim profile rectangular model. This holder is designed to use common suction cups instead of hook and loop fasteners. I hate using the double-sided tape mounts because they leave such a sticky mess on the windshield when removing them.
I designed this in Fusion 360 and included 2 versions. One has an open top and the other adds small retaining clips at the top to hold the device a bit more securely. Both STEP and Fusion 360 source files are included for your remixing pleasure.
Printing
Be sure to print them with PETG, ABS, ASA, or another material that can stand up to the heat inside your vehicle.
Supports are not needed, but I did print mine with tree supports enabled for the suction cup holes so they came out a little cleaner.
Suction Cups
The suction cups are commonly available in hobby stores. The ones I used are 45mm in diameter and the center post is 12mm in diameter. They install easily into the holder with a twisting motion like inserting a screw.
Note: These are non-affiliate links
These are similar to the ones I found at my local hobby store:
https://www.michaels.com/product/15-suction-cup-hooks-by-artminds-10049988They are easy to find on Amazon as well:
https://www.amazon.com/Universal-PVC-Suction-Hook-Supplies-Office/dp/B07WGRS1D5