Bench Power Supply with ATX PSU (w/ XH-M229+SK35)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to convert my ATX PSU to an adjustable bench power supply, for this I remixed 2 different models.
- Ocena
- 4,667 / 5
- Polubienia
- 108
- Pobrania
- 996
- Wydruki
- 3
- Wyświetlenia
- 4419
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
The model that brotherchris made with the XH-M229 switchboard was fine, but it didn't include an adjustable unit, so I modified the model a bit and integrated the SK35 (XYS3580 can also use) buck/boost converter case prepared by fjkraan into the model.
There is also a slot for a 4-pin molex output on the power supply. I soldered the 8-pin connectors from the PSU and fed the SK35 from there.
I used M3 insert nut for the 4 rods connecting the front and back of the model. Screwing in the rest of the model was done with M3 hex-nuts and bolts.
To avoid being affected by VOCs please use your printer ventilated area or filtrated enclosure.
Slicer Settings:
- PLA @ 200/55°C (nozzle/bed)
- 0.20mm layer height
- Infill with %20 density
- Brim with 5mm
- no need support🎉