Jet AFS-100B Exhaust Deflector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With my Jet air filtration unit close to a wall I needed a deflector to direct the flow of air. This is that solution.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
When I mounted my dust collection pipe to the ceiling in my basement shop it meant that one of my Jet AFS-1000Bs had to be moved from the ceiling to a wall. Worst was that it had to be put close to another wall where the exhaust actually bounced back and caused other issues with the filter being able to do its job well.
This model prints in 4 parts and needs to be glued together using CA glue. I printed this using Prusament PETG and used magnets to secure it to my air filtration system.
Magnet information:
- Diameter 0.250" (6.4mm)
- Thickness 0.100" (2.5mm)
The magnets can be found at Home Depot → link and at → link or a substitute can be used from Amazon → link.
Here are the material and time estimates for printing using PETG with 0.20mm Quality printer settings on a MK3S+.
| Part | Material | Time |
| A | 79.49g | 6h50m |
| B | 191.42g | 16h5m |
| C | 71.86g | 6h7m |
| D | 178.69g | 14h38m |
| Total | 521.46g | 43h40m |