1 / 7
iPhone13/14 phone holder for Toyota GR-Yaris, left/right hand drive
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
iPhone 13/14 holder with USB charger and MagSafe slot for GR-Yaris.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 2606
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
Disclaimer: Using phone holders/stands in a car is prohibited by traffic regulations in some countries. Use on your own risk.
Phone width
This holder component fits iPhone 13/14 case width about 75.5 ~ 76mm. Slightly scale the holder in the width direction still works.
The width test component is a small section of the holder component for a quick test fitting. Scale the width test in the width direction and print it until it fits your phone case. Apply the same scale ratio to the holder.
Materials
- ABS or ASA filament (PLA is not recommended for its low temperature in a car scenario)
- Bolt M5 x 45 (1)
- Bolt M3 x 15 (2)
- Hex nut M5 (1)
- Square nut M3 (2. Hex nuts are applicable but could spin more easily)
- Washer M3 x 8 x 1.0 (2)
- Polyurethane sticky pad 6cm x 8cm
- 3M VHB tape
Slicer
- For right-hand-drive users, just mirror the joint in the slicer. The other 2 components are symmetrical.
- Wall: 1.6mm or thicker
- Infill: 20% or more
- Use supports.
