Jazz III Guitar Pick Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The retaining pins expect a spring with a (roughly) 8mm inside diameter.
- Ocena
- 0 / 5
- Polubienia
- 38
- Pobrania
- 284
- Wydruki
- 1
- Wyświetlenia
- 2017
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
The retaining pins expect a spring with a (roughly) 8mm inside diameter. I used a 27/32" X 3/8" 0.32 compression spring, and cut it maybe 5/8" shorter. You don't want a ton of pressure, especially when full.
Comfortably fits about five picks (Jazz III only).
Not recommended for max-grip Jazz IIIs, as they almost completely lock together with
even minor pressure. Primetones work great, though.
Should snap together without glue and stay put, but that will also depend on your tolerances.
2018-06-12
- Increased plate height so that it cant slide out through pick slot
- Decreased size slightly to only fit standard sized jazz III picks.
2018-06-13
- Redesigned smaller: Shell now 1.5mm instead of 1.5*2 + tolerance, with a shorter base.
- Tighter fit for base, to make up for reduced contact area.
TODO
- Remix for maxgrip picks
Print instructions
Requires supports for the outer shell. Print pieces flat side down
Place spring over retaining pins in the base. Place spring over retaining pins in the flat plate piece, and squeeze together, and slide cover on.
Press cover together until the three bumps on the side press into the shell and lock in place. Apply glue maybe.