Prusa MK4 / MK3 Shortened Spool Holder Endpart
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shortened Spool Holder Endpart, enough to hold 1kg filament spools in order to hold 4 spools at a time
- Ocena
- 4,5 / 5
- Polubienia
- 36
- Pobrania
- 150
- Wydruki
- 2
- Wyświetlenia
- 1038
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought from Prusa a second original spool holder in order to hold 4 spools at a time in my little enclosure.
But original holders endpart are way too large for only 1 kg spools and take too much space in my expected configuration.
So, I took Andy0838 base and remixed it to shorten endparts by 3 cm, making them 6 cm long instead of 9 cm. Multiplied by 4, gain was 12 cm, enough to load and unload 1 kg spools without problem, even for those in the middle.
Printed in 50% infill to be enough resistant and not breakable as would be a 100%, took around 2h each on a MK4.