1 / 11
Beer bottle opener in the shape of a beer bottle — zdjęcie 1
1 / 11

Beer bottle opener in the shape of a beer bottle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Open your beer with the matching opener

Ocena
4,5 / 5
Polubienia
38
Pobrania
205
Wydruki
1
Wyświetlenia
1540
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Update:
I added a new model for the insert, which can be used with a 50 Euro Cent coin (24.3 x 2.4 mm), instead of the washer for M12 bolts (23 x 1.9 mm)

 

 

This is a bottle opener in the shape of a long neck bottle, like German breweries often use for their beer (is this bottle shape also used in your country?). 
Inside the bottle is a small cavity to collect a few crown caps.
As I think, this is a great souvenir for a party. That's why I printed several of them myself ;-)


I created a model of a long neck bottle and made a cutout for an insert which functions as a bottle opener.
I then divided the model into two parts that can be printed separately and reassembled via some sort of bayonet lock.
The insert with the bottle opener is pushed into the bottle via two rails and snaps into the correct position. The connection is somewhat tight so that nothing wobbles. On some of mine, I had to push a little harder until the insert was fully seated in the bottle. I recommend a folded cloth on a table with the bottle pressed down on it to snap the insert into place.
The small gap dimension require a precisely adjusted 3D printer, which is fortunately given with my Prusa printers. I hope everything fits with your printer as well.

I printed the bottles in different glitter PLA filaments from Prusa and Ziro. For the insert I used PLA+ to get a higher strength than with standard PLA.

A washer then needs to be placed in the insert. The cutout provided for this is 2 mm wide. A washer for M12 screws has the correct size (approx. 23 x 1.9 mm). Maybe a coin of the right size will do as well, but I didn't check that.
Some of my washers were a bit bent and needed some force again to be pushed all the way into the slot.

To make sure that the seam on both halves of the bottle is on the same side after joining, I set the seam position in PrusaSlicer to "rear" and also rotated the bottom part 90° clockwise (in the slicer: -90° or +270° around the Z axis).

Supports are required for the cutout in the lower part of the bottle and for the overhangs of the upper part and the insert.

I do not recommend using the variable layer height in the PrusaSlicer when using glitter PLA. The different layer heights will otherwise be visible as stripes on the surface of the bottle.

Tagi