Dial indicator mount for Creality K1

===============Update 30Aug===============
a lot of people don't know where to view the bed mesh, you just need to go to your browser. Go to http://192.168.50.229/#/home change the ip to your machine ip, enter the page, then change the url into http://192.168.50.229/#/prepare and enter again, then you will see your bed mesh
=========================================

After further testing, confirm this will work fine if you have use 2 longer screw and screw it together with the original fan casing.

There are few ways to level the bed:

5.) [15Sept update] this might be the best way to tram the bed(for now, in theory), but if your mesh difference is higher than 2.5mm, recommend to follow Creality's official approach then do this one - custom bed spacers for bed tramming

1.) The official approach by Creality - bottom out reset leveling

2.) The Bed leveling fixture by @pungo120 (but i think can't just print out, might need to use aluminum extrude to make one.)

3.) Paper method by @册空科技

My suggestion is to use method 3 with dial indicator, but do not fully release the belt, adjust by skipping teeth 1by1.

4.) [17Aug update] finally found a video of skip a teeth method by @Lin_koko18 (and @Newtd ?)

YOU DON'T NEED a dial indicator or print this mount if you are using method 1/3/4. But I would say it is easier to have a dial indicator for method 3/4. Because for newbies, the feel of the paper might be hard to tell the difference

*WARNING, if your machine have been damage from shipping, the main frame might not be straight anymore, in that case none of the methods above will help you, what you need to do is contact Creality and ask for replacement*

If you prints are not sticking to the bed, check out point 5 in this post . 

Remember!! “if it ain't broke don't fix it” and trust the ABL

a.) make sure you have clean the plate(with warm soap water and a brush, then air dry) 

b.)Then tram your bed if needed

c.) Then adjust the flow settings(do flow calibrations), if still can't get good result on first layer, 

d.) Then mess with z-offset. Z-offset is hidden in advance setting for a reason, but you can turn on advance setting and use the search box to access it.