Raspberry Pi3B/3B+ Case tweaked - Bottom mountable for Prusa Mini/Mini+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the raspberry pi3 case, originally designed by Joe and remixed by Wilts01 to enable bottom mount.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 67
- Wydruki
- 2
- Wyświetlenia
- 500
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a remix of the raspberry pi3 case, originally designed by Joe and remixed by Wilts01 to enable bottom mount. Thanks to all original creators!
Changes in remix:
- Remove the side mount, the side wall is flat again
- Added 4 bottom 2.5mm holes that match the holes of the rasperry pi itself.
Other compatible prints:
Usage
When mounting the pi via the holes, use a spacer between the case bottom and the raspberry pi. This ensures that the PI has a fixed width and prevent it from getting pressed to much against the bottom. This could damage your sd card due to the physical stress.
One M2.5 Nut + M2.5 Washer did work very well for me.
Print instructions
Just print it laying flat on the ground. Use support on the SD card hole, otherwise it gets a little bit narrower. Infil of 15% is fine.
Optionally you can finish the top layer with ironing, to give the edges a smooth finish.
Print Example
The print of the pictures were done with:
- Prusament Galaxy Black PLA
- 0.2mm Quality Profile
- Prusa Mini+