1 / 16
Höhen und Neigungs- verstellbarer Handyhalter, verstellbar, Smartphonestand, Smartphone, Handy — zdjęcie 1
1 / 16

Höhen und Neigungs- verstellbarer Handyhalter, verstellbar, Smartphonestand, Smartphone, Handy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Hier ein Höhen- und Neigungsverstellbarer Handy- und Tablethalter. Den Knopf zweimal drucken. Es werden zwei…

Ocena
5 / 5
Polubienia
10
Pobrania
135
Wydruki
1
Wyświetlenia
1232
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Hier ein Höhen- und Neigungsverstellbarer Handy- und Tablethalter.

Den Knopf zweimal drucken.

Es werden zwei M5-Inserts und 2 M5x10 mm Schrauben benötigt.

Gedruckt mit PLA, 4 Wandlinien und 25%-50% Infill. Wer den Sockel schwerer möchte, erhöht das Infill oder füllt während des Druckens Sand rein.

Die Ablagen sind in verschiedenen Größen: 12 mm, 15 mm, 20 mm, 23 mm - je nachdem, wie dick das Handy oder Tablet ist.

Die Ablage wird mittels z.B. Sekundenkleber an das Klemmteil2 geklebt.

Für Upgrades / Verbesserungsvorschläge bin ich offen.

Edit: erstes Upgrade der Knopf für eine M5 Mutter falls kein insert verfügbar.

Die Öffnung ist etwas kleiner daher die Mutter auf eine Schraube drehen, mit Feuerzeug warm machen und rein drücken.


Height and tilt adjustable cell phone and tablet holder.

Print two button, you need two M5 inserts and 2 M5x10 mm screws.

Printed with PLA 4 wall lines and 25%-50% infill who likes the base heavier increase the infill or fill it with sand during printing.

The trays are in different sizes 12mm, 15mm, 20mm, 23mm depending on how thick the phone or tablet is.

The tray is glued to the clamp part2 using e.g. superglue.

For Upgrades / improvement suggestions I am open.

Edit: first upgrade the knob for a M5 nut if no insert available

the hole is slightly smaller therefore turn the nut on a screw, warm with lighter and press in.

Print Settings

Printer:

FL Sun SR

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25% - 50%

Filament:

Spectrum PLA

Black Post-Printing =============

Category: Mobile Phone

Tagi