Louis Tomlinson Walls Spinning Dartboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This was obviously inspired by the Walls video clip from Louis Tomlinson.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- People
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This was obviously inspired by the Walls video clip from Louis Tomlinson.
It's the design of a dartboard that spins and always (or that's the idea) stops with the silhouette of our protagonist in the correct vertical position.
I have printed all the files face down on a glass bed, this way it has a glossy finish.
See more: https://www.instagram.com/p/CNK1Re9FfQM/ https://www.instagram.com/p/CNdG5hwre7z/
For printing the dartboard there are 3 options:
- Print Black, White, Red, BackBolt separately and glue everything.
- Print Black, White and Red like in the video (linked below this) and then separately print BackBolt and glue these two prints. Use z-hop 0.7mm (Black, White and Red height are 0.6 mm) to make sure that the extruder doesn't bump on any previous print and also enable z-hop when retraction.
- Print White, Red and BlackBackBolt like in the video with 0.7 mm z-hop and enabled z-hop when retraction also.
Colorful 3D Prints on a Single Extruder Printer // Artistic Phone Cases by Make Anything:
Nut fitting problems: if you have any problems try to scale down or up the model a little to try to make the best fit with the calibration and resolution of your 3D printer.
Print settings for each piece below.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Filament: BQ PLA White, Black, Red
Notes:
- Base: For stability try to print with the maximum infill. If 100% takes too much time or filament I think 50% would be enough, maybe a little less. Layer height 0.2mm it's perfect.
- Support: this part supports all the dartboard weight so around 25% infill will be enough. Layer height also 0.2 mm.
- Weight: 100% infill and layer height doesn't matter I did it with 0.2mm.
- Nut(x2): 10% infill and 0.12mm layer height. This nut isn't flat, I added an angle on one side so when it's screwed will be flat to the support piece, this helps that when the dartboard is spinning it doesn't wobble as much. I printed 2 nuts so one goes before the Support piece to give the dartboard space to spin, I glued that nut to make sure that the Bolt will not come out of the back.
- Nut End: Same as the nut.
- Red/White/Black: infill doesn't matter it will be 100% because it's only 0.6mm. Layer height at 0.2 mm for everything. I used Concentric in the Bottom Pattern Initial Layer.
- BlackBackBolt/BackBolt: infill at 15%. Layer height also at 0.2 mm. Use also Concentric in the Bottom Pattern Initial Layer.
- LTsilhouette: I did 100% infill because my glow in the dark filament was a little translucid and I didn't want to see the grid of the infill, but if it's not your case 5% or 10%. Also 0.2mm layer height.
