Wallmount System universal attachable hook (Allit StorePlus)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a universal hook that can be mounted to other holder-thingys, or anything really, to make them compatible with…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 308
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a universal hook that can be mounted to other holder-thingys, or anything really, to make them compatible with the Allit StorePlus system (and many others). You can either use two countersunk screws of up to 3.5mm diameter, or you use ca-glue/superglue to fix it to other 3d printed parts. For heavier loads, I recommend adding extra supports to your holders in order to distribute the load better. See my example photos. (last three have makeshift supports out of pieces of wood, to offload downward forces against the wall.
Printing:
For stability reasons and to avoid supports, it should be printed standing upright, so I recommend using brims to secure adhesion.
Prints best on 0.6mm nozzle with 0.8mm extrusion width, 0.4mm layer height, high temp for better adhesion. PETG works without a fan, for PLA you should use a fan or you'll end up with warping like I did. You can place 4 pieces close to each other so the brims overlap, you'll save some material and print time. Don't print too fast, this is a small part that prints quickly anyways. Print slowly and enjoy better layer adhesion.
If you want to support my work, consider leaving a tip or a friendly comment here on Printables. :)
Category: Tool Holders & Boxes