Dremel 4000 table clamp attachment / mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modification of cheap c-clamp rotary tool stand to fit Dremel 4000, best used with flex shaft.
- Ocena
- 0 / 5
- Polubienia
- 81
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 1919
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
With my old no-name rotary tool I received a really nice desk clamp that I used a lot but when I have upgraded to Dremel 4000 it didn't fit into original clamp so I did model it in fusion 360 to make it wider.
Only hardware you need (apart from original no-name holder) is a m5x20 bolt with a nut (I stole mine from original holder too).
Base that fits the clamp has a diameter of 45mm, hole for Dremel has a nominal diameter of 52mm but can expand quite a bit if needed (only limits are bolt length and elasticity of the filament).
Unfortunately I can't find any online listings for similar holders, I got it many years ago from a local hardware store.
Printing tips: printed standing up without supports, you need to cut small pieces of plastic near the screw after printing.