Flexible Actuating Tail Scorpion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print-in-place quick print flexi scorpion with working tail.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 271
- Wydruki
- 4
- Wyświetlenia
- 1518
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This is a single unit with a captured tail actuator slider. Just fish the ribbon back through the tail and snap the button into the slider and you're ready to flex it.
I printed this model in PET-G and for a fast print I used a 0.4mm nozzle and the draft 0.3mm layer height (prints in about 35 minutes).
I didn't use any supports and it printed out fine. if the slider doesn't have enough bed adhesion, then you can fill the bottom of the slider in with a thin layer of plastic. I had left it open to provide better grip when actuating the tail.
Now you can slide the actuator and the tail will flex. Watch that it doesn't sting you :)
Sized to fit on both the Mk3 and the smaller Mini (although you may need to rotate the model to print at a diagonal)
I have included the step file in case you wish to add leg articulation or some better contouring
Enjoy!