Rollholder bearing RMX for big filament spool holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
less friction version of the rollholder for big filament spool holder
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 83
- Wydruki
- 2
- Wyświetlenia
- 347
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
after printing the big filament spool holder by Boogie, using it for a while, really liking the sturdy design and printing a second one I felt like having less friction in the system would suit my setup.
so I cut the original rollholder a little in the center where it touches the spool and slotted 608 bearings in, all other dimensions are still the same.
the idea was that three bearings could even make it work with less wide spools, but I didn‘t test this so far.
was really happy with the fit and functionality but now there was a tendency to unspool by very little forces applied to the spool. that led me to use the center bearing slot for a printed dummy-bearing acting as a brake, but you could even use two or three of them without any bearings to reduce friction compared to the original model.
another advantage is a slight cut in material and print-time.
once you found your combination of bearings and brakes you can glue the axis into the slot to make the removal and insertion of the rollholder a little easier.
the axis and brakes have a flat side for an easier print.
as always I highly appreciate every like, rating or make, same for remixing and sharing.
donations will be forwarded to sea-watch.org