Ubiquity UAP-PRO Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This has been remixed from the "Ubiquiti Unifi AP Mount" made by "ThePhilStrongProject". This version is made…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 281
- Wydruki
- 0
- Wyświetlenia
- 856
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The model shown here has been remixed from the excellent "Ubiquiti Unifi AP Mount" made by "ThePhilStrongProject" on Thingiverse.
This version of their model is made specifically to fit the Ubiquity UNIFI Access Point model “UAP-PRO”.
I removed the raised screw mounting bosses from the inside of the mount, so that the mount would work with the UAP-PRO model but this left the mount a little thin, so I thickened the base of the mount by 1mm to make it more resilient.
Printing this on my cheap printer took almost the complete print bed, so I used an 8mm wide brim to ensure the part would not warp. The entire batch worked flawlessly both in printing and in ultimate fitment to the access points… with one caution: Don't torque the mounting screws too tight or it can warp the mount, making it hard to attach the AP.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
20%
Filament: Inland PLA White
Category: 3D Printing