1 / 2
Battery Cover for Paw Patrol Toy #16603 — zdjęcie 1
1 / 2

Battery Cover for Paw Patrol Toy #16603

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Battery cover for the Paw Patrol Transformer Toy (#16603)

Ocena
0 / 5
Polubienia
2
Pobrania
17
Wydruki
0
Wyświetlenia
301
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Purchased a box of assorted Paw Patrol toys for our kids, this one was missing the battery cover, so here's a “good enough” replacement.

All the features seem to be offset by 2-3mm, I assume to deter copies/clones. It is strongly recommended to measure the features just in case different batches have different offsets.

Design Information

The batteries require a bit of pressure to touch both terminals, hence the 3 circular bits on one side. If tightened enough, the bolt can snap the battery cover since the bolt hole area does not have supports touching the main part of the toy. The bolt can be tightened a little bit to keep it in place. If your kids are devious enough, they'll probably figure out how to open it. Maybe add some loctite to the bolt. Or let Darwin take care of 'em.

Required hardware

  • 3 LR44 batteries
  • 1 M3x15mm bolt with round head (couldn't find one with a flat head)

Tagi