Tamiya TL-01 Saddle Pack LiPo Battery Tray Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Project is still WIP!
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 657
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a conversion mod for the Tamiya TL-01 that allows you to use a pair of 2s or 3s saddle pack LiPo batteries and use generic cheapy brushless ESC’s (goolRC, etc)
This project is still WIP!!! - I wanted to test it further before release and make a ‘no cut’ version but never had the chance for various reasons. So I’ve decided to release it as is. It does work, but you do need to trim the side of the TL-01 chassis a tiny little bit and it will gradually smash itself apart if printed from PLA if you drive on rough enough ground. I toyed with the idea of potentially fitting a sheet of brass/steel/whatever to the underside of the car to lessen off-road/rally damage, but I never got round to it myself. Most screw/boltholes reuse existing holes in the tl-01 chassis. This model's designed to clamp to the side of the car and interlock with most of the existing grooves to carry the battery weight (rather than stressing out the plastic around the bolts), it also allows you to slide the trays back/fourth a little to adjust their position (stop front tyre rub/etc.)
Provided as is and without warranty, I'm assuming you're doing this to a beater/old RC that doesn't mean much to you.
Required parts
various bolts (*4x M5 by 0.8mm pitch for the old nimh battery block model. The rest of the holes aren't really threaded, anything that'll bite into them will do.)
cable ties (*mounting this way should hopefully allow more than just one size/brand of ESC to fit to the lid)
4x Velcro Straps (*the ones with the plastic loop/ring) 20cm long, 2cm wide
Max/Tested Battery dimensions = 15cm long (*total length’s the important one here, longer batteries collide with motor and steering), 2.5cm wide (*3s, wider might be ok), 4.5cm tall (*taller might be ok.)
EDIT ~ 23/06/23: whoops, i left a part of the model out. I've added the missing resistor tray/block stl and updated bolt thread dimensions in the description. I can't remember if the shell strut braces were my 3d model or not, so they aren't included.