Rotating Drill Bit Holder, 3 designs 1mm to 10mm in 0.5mm increments.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill bit holder, Skadis board and screw fitting holders. Spinning to aid access to drill bits. 3 designs
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 829
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have placed a link to the original document above so that you can copy and modify it.
After trying and changing other people’s designs, I went onto design this.
I used a cut-down version of my PTFE and electrical tape holder as a starting point. I was unsure if I would mount it on the IKEA Skadis board or screwing to a wall, so I made both versions. On completing V1 of the drill bit holder I found I had numerous spare small drill bits, so I changed the design of the mounts, hollowing out the middle to accommodate other bits and items.
So as I mentioned above, I hollowed out the mount to take some of the spares. This led to V2, with slots for a larger number of the smaller bits, but I found the drill bits wobbled around. So I moved on to V3 with multiple single holes. This ends up being my preferred model.
When printing the holder, I wanted to colour-change the numbering. However, I do not have a multi-colour print system. So to achieve the colour change, the drill bit holder was rotated on the Prusa slicer so that the top was parallel to the base.
Within the design, you can change the text size. It is currently set at 7. I have not tried a larger size as this may require further changes to the design.
I have successfully printed all 3 designs using a 50/50 original/reprap Prusa mk3+ through the PrusaSlicer on the preset 0.20mm Quality setting.
As we all use potentially different printers, slicers and filament. So just in case there is a “Drill hole Test Print” model save printing the hole model and finding your bits do not fit. The “Drill Bit Hole Variance" along with the “Drill hole test print”, enable you can make changes to your print when using your own copy of the original file in Onshape.