Cone Remix to DPs Cupcake Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of DPs cool cupcake design. Wanted to see if adding a cone extension could enhance upright floatation stability
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 295
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
Printed with MK3S+/Generic hi viz green PETG/0.2mm QUALITY/organic supports
Remixed using TinkerCAD
This was my first remix and I am new to 3D modeling, so feedback/suggestions welcome. Thanks!
**UPDATE: Initial tests did not yield intended result. I used only a 15% infill and the float tends to sit horizontal on top of the water - not terrible in terms of visibility, but not what I was hoping to see. Since the top is hollow and the cone bottom is not, I think a greater infill density (>20%) might shift the weight toward the bottom of the float and correct it's floating position while still remaining buoyant. I'll test that next.