1 / 32
Abyss2022 quadcopter frame - 3.5", 4.0", 4.5", 4.7" (DJI Spark) and 5"
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed, modular quadcopter frame.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 510
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (16)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (8)Powiązane
3D printed, modular quadcopter frame.
General notes
- Supported propellers: 3.5, 4.0, 4.5, 4.7 and 5 inch
- Motor mount pattern 12x12 for all except 4.7 inch (this one is dedicated to DJI Spark’s 3x11mm mount type)
- Supported camera mount 19x19mm
- Supported FC / Stack mount patterns: 16x16, 20x20
- Mount for Beitian BN-880 GPS/Magnetometer inside Canopy („Monster” version)
- Huge, under the stack bay for Capacitor, RX, barometer
- In-arms tunnels for motor cables
- In-arms tunnels for 868-900MHz receiver antenna (4.7+ inch arms)
- Use 8x 8mm M2 screws for motors and stack
- Use 12-16x 22-24mm M3 screws for canopy
- Frame weight depends on how strong you want to have it (40-70g)
- Designed to be (almost) supportless 3D print, print canopy on the 'camera face'
Keep the flight weight below 180g to survive the typical crashes, but (you know) 3d printer frame is ok for flights, not racing/crashes.
I have good results using Fiberlogy Impact PLA (it seems better than PETG), use NYLON for more stiffness.
Version history
- 2022-07-10 Initial version (v156)
- 2022-07-11 Added stars edition: je**pi or 'idi nahui', meaning depends on your needs (v151)
- 2022-07-11 Extended USB plug hole in Monster canopy (v160)
If you like it - please click ‘Like’ to support my designs ;-).
