HSW 4x Tweezer Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for 4 tweezers for Honeycomb Storage Wall. Versions with 2 pegs and rotated peg(s) also available.
- Ocena
- 5 / 5
- Polubienia
- 34
- Pobrania
- 265
- Wydruki
- 6
- Wyświetlenia
- 901
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
Holder for 4 tweezers. Remixed from @Kajry 6-tweezers holder. Added version with 2 pins for greater stability and also a version with rotated pin(s) to fin into the Honeycomb Storage Walls mounted 90° rotated compared to the original design.
Dimensions of the slots are 12x5mm each; and 48mm deep.
Note: version with 2 pins contain my own pins which were designed for a very tight fit. Either use hammer to hammer then into the inserts, or slightly downscale the model.
Printing
Print upright. No support needed for single-pin versions; for 2-pins versions, I recommend organic supports.
I printed mine in PETG with 5% infill (you can probably even have no infill), 6mm nozzle, and 4mm layer height; however, any combination of material, nozzle diameter, and layer height should work - this is a very simple model, so there are basically no restrictions.