Shoei RF-SR Helmet GoPro Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The idea behind this bracket was that I wanted to have a streamlined mount for a GoPro.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 141
- Wydruki
- 0
- Wyświetlenia
- 1697
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
I'm not sure how well it will hold up yet, so I suggest using a tether from your chinstrap to the camera.
The idea behind this bracket was that I wanted to have a streamlined mount that did not look bolted on to the side of the helmet, or onto the top. I also wanted a chin-mounted GoPro mount, but sadly the Shoei RF-SR helmet has a chin area completely occupied by the intake vent. A clip on mount may work, but I have not started development on one.
The RF-1200 has a much better space for the mount. In addition, I wanted the GoPro to sit with the lens as close to the center line of the helmet as possible. For a standard GoPro this works well, but for the Session, the lens will be slightly off to the side.
As a final design goal, The chin vent needed to remain operable, so the slight offset helps with this too.
It is designed to fit on the lower right side of the helmet as pictured (affixed with double sided tape)
Print instructions
Printed with 2mm walls and 2mm top and bottom. Supports are important for this model as we want the GoPro mount section to align perfectly with the layer lines for maximum strength.