Oculus Quest 2 Grip (with strap hole)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is basically just the model by tigerflip, but with a hole cut into the bottom.
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 230
- Wydruki
- 2
- Wyświetlenia
- 903
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is basically just the model by tigerflip, but with a hole cut into the bottom. I measured the straps on my controller to ensure they could pass through (including the plastic thingy) but the fit is snug. You should pinch the strap and push it through a little, then line up the plastic clip to go into the hole. Then, if you pull the strap, the controller should slide right into the grip and fit snug without the need for glue or anything like that (or at least, that's how it worked for me)
Print Settings
Supports:
No
Resolution:
0.2mm
Infill:
30%
Filament:
Black
Notes:
I printed mine at a fairly low quality; 0.6mm nozzle with 0.2mm layer height, and 100mm/s in Cura. It has some obvious imperfections, but it feels comfortable and fits well, so I dont mind.
I used 30% cubic infill, but I also changed the wall thickness to be 3 lines thick.
This shouldn't need supports. I personally used a brim, but that's up to you.