1 / 2
LumenPNP v3 Drag Feeder Tape Hook
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This plug-n-play tape hook keeps your cut tape components neatly coiled beneath your LumenPNP drag feeder.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 901
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
Keep your components neatly coiled beneath your existing drag feeders with this minimal print. It inserts snugly into the M5 screwhole and requires no modifications to your feeders. Say goodbye to big loosely hanging coils of components!
Print Settings
The assembly in the pictures was printed at the following settings:
- Printer: Prusa Mini+
- Print Settings
- 0.4mm nozzle
- 0.15mm layer height
- 15% infill
- Filament: Prusament Vanilla White PLA
- Supports: none (if printed in delivered orientation)
- Brim: none
Print Instructions
- No supports required if printed in the delivered orientation. Make sure you have good bed adhesion.
- Print 1 test piece and check fit on your feeders. You might need to scale it up/down a tiny bit to get a nice fit.
Assembly Instructions
- Coil your cut tape neatly into a loop and slip it through the crack in the hook.
- Insert the rippled dowel in the M5 hole on the back of your feeder, it should fit snugly but come out with minimal effort.
- Insert the leader on your tape into the feeder.
- Pro-tip: write the component model # on the back of your cut tape (near the end) so you don't forget what components it contains.
- Enjoy!