Coaster Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your coasters organized with a holder that stays in place.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 58
- Wydruki
- 1
- Wyświetlenia
- 231
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Keep your coasters organized with a holder that stays in place. Designed for coasters ~100mmx100mm. There are variants uploaded from 2 to 5 coasters, but it's easily modified so if something doesn't work right for you send me a message and I'll upload a new one.
The cutouts on the bottom are sized for large Command picture hanging strips. Leave the “tail” piece attached and cut in half lengthwise.
Print Settings
Resolution: 0.1mm. There is bridging required for the bottom cutouts, and going much higher then this will make it not work as well.
Infill: 15% Gyroid
Supports: No