Belt Clip Tape Dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple to print tape dispenser you can clip on your belt that takes standard 19mm x 25.4mm scotch tape rolls.
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 150
- Wydruki
- 0
- Wyświetlenia
- 931
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I frequently have to tape up signs at work on doors and have no where to set down a tape dispenser. I made this as a quick and easy to print tape dispenser that I can clip on my belt and refill with stock scotch tape rolls whenever needed.
I made 2 version of the dispenser, V1 is the blue one pictured and it has smaller teeth with a more square block, this one is more for if you'd like to take the metal teeth plate off of a disposable tape dispenser and screw it on as the teeth on it are so small they'd probably wear down fast. V2 has much better teeth if you don't want to use a metal teeth plate from a disposable tape dispenser and it also has a rounded top part of the belt clip so if you're heavier like me it doesn't dig into your hip.
I printed both versions using the stock nozzle on my Prusa mini and just sharpened the teeth a bit with an exacto knife. I used PLA and it's holding up just fine but I'm sure PETG would probably hold up much longer. I also made both versions with teeth on both sides so you can use it regardless if you prefer it on your left or right hip.
Please feel free to remix this and make it better! I'm very new to 3D modeling but had a blast building it!