playing cards case with closing lid using clips (available for custom sizes with parameters in f3d file)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A while back i create another closing playing cards but it had quite a lot of problems I tried to fix all of them.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 74
- Wydruki
- 1
- Wyświetlenia
- 671
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
How to change size -
1 - measure your playing cards size
2 - open the f3d file in fusion 360.
3 - press s to open the search box
4 - enter “change parameters” to the search box
5 - enter the measured size of your playing cards to the corresponding parameter
6- make sure to add about 0.5mm or more to the measured size to ensure the cards go in smoothly
7 - press ok, wait for fusion 360 to do its magic and then export to stl
8- enjoy!
*Note - if there is a problem with one of the fillets or chamfer then the value is too big go to the time line press edit on the highlighted cube and enter a lower value. it will only occur on quite small case sizes.
*Its best to print the clips from petg or any other semi flxible metrials
*The clip fit parameter is for how tight should the clip fit into the holes of the case
*Make sure to glue the clips after inserting them a little blob of super glue will do the trick.
*Its best to print the clips on their side with a bit of support to the tip to ensure that the contact point of the gliding surface is smooth and not disturbed by layer lines