Honeycomb Wall Holder for Combination Squares and Rulers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Honeycomb Storage Wall Holder for Combination Squares and Rulers
- Ocena
- 5 / 5
- Polubienia
- 86
- Pobrania
- 440
- Wydruki
- 2
- Wyświetlenia
- 1784
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a holder keeping your combination squares or rulers nicely on your Honeycomb Storage Wall (HSW) for easy retrieval. The model was designed for squares / rulers with a thickness of 2mm. If this is useful to somebody, I can upload holders with wider slots.
This model is a remix of the original sized ruler holders by BalooDK.
What is needed?
- 2x print file ‘HSW_Holder_for_small_Combination_Square’
- no additional inserts needed
How to print
Use support for insert attached to the holder model. Or print without support and make manual corrections (e.g. by pulling off some unclean parts with pliers or by sanding a little - for me, this was perfectly fine).
I suggest to stick with the original suggestions for printing holders and inserts for the honeycomb wall: Use any material you like (I used red PETG), with layer height of 0.2mm, 4 perimeters and 20% infill.