Runcam mount for trx4m bronco.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
camera mount for a trx4m bronco.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 911
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
i made this to hold a runcam behind the windshield of the trx4m bronco.
i did print it so it would lay down sideways so when installed the layer lines are vertical. used 2 of the extra screws that came with the runcam to change the oe screws to longer ones. if i need to i will prob add a Dab of hot glue or some double sided sticky tape to the underside of the flat to hold it to the trans. thats the reason behind the wider bottom plate. tumbled around in the woods for 20 min and it held up sofar.
print time is roughly 18 min for my ender 5 plus.
printed with
.4 nozzle
.2 layer height
i print with 3 walls.
printed with 10% infill.
i used the allen key that removes the screws on the trans to open the printed holes to fit the screws. pictured is v3 one loaded is v4 beefed up the tabs just a hair and made it so it wouldnt require supports. the hole for the cam screw is a little large to allow wiggle room. i will be fully testing the cam when i get the battery sorted out as i can power camera from the lights port but the second i turn the camera shuts off. going to add a small power bank to run the cam off of.
